What is intake manifold runner control actuator?

The Intake Manifold Runner Control (IMRC) is an electrically actuated system consisting of a motorized actuator with an attaching linkage for each housing on each bank. The system is designed to give the engine the best characteristics over its operating rpm range by combining two intake manifolds in one.

What is an intake manifold runner position sensor?

The runner position sensor, also known as the runner valve, controls the volume of air entering the intake manifold. The runner valve controls a flap in the intake manifold, which will open or close depending on the air requirements of the engine. It is designed to help optimize the air-fuel ratio (AFR) of the engine.

How do I fix code P2008?

What repairs can fix the P2008 code?

  1. Intake manifold runner flaps unstuck.
  2. Wiring harness replaced or repaired as needed.
  3. Intake manifold runner control solenoid replacement.
  4. Repair of poor electrical connection.

Can I drive with P2015 code?

Can you still drive with a P2015 VW Fault Code? The short answer is yes, most of the time you can, but it is not advised. There is a certain aspect where the vehicle absolutely shouldn’t be driven and that is when the flap motor arm is stuck open.

Can you spray brake cleaner on intake manifold?

Brake cleaner, however, is not as suitable for an alternative. Therefore, brake cleaner can cause adverse effects when sprayed around a plastic intake manifold, or onto rubber-tipped needle valves found in carburetors.

What is P2015 code?

What the P2015 code means. The P2015 code means that there is out of range performance from the bank 1 intake manifold runner position sensor. When this occurs, the ECU detects the out of range performance as it is looking for a specific values and when they are not seen the DTC P2015 is set.

How to check for a Mazda p2009 code?

Start by checking the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. What does this mean? The cost to diagnose the P2009 MAZDA code is 1.0 hour of labor.

What does p2009 stand for in PCM?

Although generic, the specific repair steps may vary depending on make/model. I know from experience that a stored code P2009, means that the powertrain control module (PCM) has detected an intake manifold air control (IMRC) actuator circuit voltage (for engine bank one) that is lower than expected.

What are the symptoms of a p2009 code?

A malfunction indicator lamp may be illuminated, and a code P2009 will be stored, if the PCM doesn’t see a significant change in MAP or manifold air temperature as expected. In some cases, multiple failure cycles will be required for MIL illumination. Symptoms of a P2009 code may include: Hesitation upon acceleration

How does the p2009 runner control circuit work?

The PCM monitors actual runner flap position and adjusts it according to engine drivability data. A malfunction indicator lamp may be illuminated, and a code P2009 will be stored, if the PCM doesn’t see a significant change in MAP or manifold air temperature as expected. In some cases, multiple failure cycles will be required for MIL illumination.