How do you make an egress staircase in Revit?

Create a Multistory Stair

  1. Click Architecture tab Circulation panel (Stair), and create the desired stair component.
  2. Click Modify | Create Stair tab Edit panel (Multistory: Select Levels).
  3. If prompted, open an elevation view or a section view.
  4. Select levels to extend the stair.

How do you add stairs in Revit?

  1. Open a plan or 3D view.
  2. Click Home tab Circulation panel Stairs.
  3. Click Modify | Create Stairs Sketch tab Draw panel Run. The Line tool is selected by default.
  4. Click to start the run. Click start point on left side.
  5. Click to end the run. Click endpoint on right end.
  6. Click (Finish Edit Mode).

How do you draw stairs with landings in Revit?

Create a Landing Component by Sketching

  1. Open a plan or 3D view.
  2. Enter stair assembly edit mode:
  3. Click Modify | Create Stair tab Components panel (Landing).
  4. In the Draw gallery, click (Create Sketch).
  5. On the Draw panel, click (Boundary).
  6. Sketch the landing boundary using the drawing tools.

What is a split staircase?

A split staircase is typically used in the entryway of a very large, grand home. It starts with a wide flight of stairs at the bottom, which leads to a landing that then separates off into two different flights of stairs going in opposite directions.

How do you draw stairs with a landing in Revit?

How do you draw stairs in Revit 2021?

To sketch the stair run, with Run selected on the Modify | Create Stair tab Components panel, click (Create Sketch). Click Modify | Create Stair > Sketch Run tab Draw panel (Boundary). Sketch the left and right boundaries using one of the drawing tools. Click Riser.

How do you change stairs in Revit 2021?

You can modify a stair footprint that you have sketched using one of the drawing tools.

  1. Select the stairs.
  2. Click Modify | Stairs tab Mode panel Edit Sketch.
  3. Click Modify | Stairs > Edit Sketch tab Draw panel, and select the appropriate drawing tool to make your changes.

How do I add a landing to a ramp in Revit?

Add a Ramp

  1. Open a plan or 3D view.
  2. Click Architecture tab Circulation panel (Ramp).
  3. (Optional) To select a different work plane, click Work Plane panel Set on the Architecture tab, the Structure tab, or the Systems tab.
  4. Click Modify | Create Ramp Sketch tab Draw panel, and select either (Line) or (Center-ends Arc).